Teel wires used for sternotomy closure. (A) Left panel is a

Teel wires used for KDM5A-IN-1 site sternotomy closure. (A) Left panel is a SEM at 60x magnification of an unused sterile stainless steel wire, twisted in a way similar to that after sternotomy closure. Scale bar = 1 mm. Right 1317923 panel is a higher magnification (10,000x) of the dashed box area in the left panel, showing the metal surface of the wire. Scale bar = 5 mm (B) Left panel is a SEM at 60x magnification of stainless steel wire after overnight incubation with MRSA strain USA300. Scale bar = 1 mm. Note the wire metal surface is coated by a film of material. Right panel is a higher magnification (10,000x) of the dashed box area in the left panel, showing clusters of cocci attached to the extracted wire and embedded within amorphous slime. Scale bar = 5 mm. doi:10.1371/journal.pone.0070360.gdebridement aimed at treating wound infection [14,15]. Given the poor prognosis of cardiac surgery wound infection complications, we sought to look for the presence of biofilm at the sternal wound site in patients undergoing cardiac surgery. This work provides the first direct evidence demonstrating presence of biofilm infection in sternal wound site cardiac surgery patients. The introduction of the concept of biofilm infection in deep SWI will help revisit wound management strategies.ResultsStainless steel wires used for approximation of the sternum after cardiac surgery were tested in vitro for bacterial adhesion, biofilm formation, and recalcitrance to antimicrobial tobramycin. In the SWI cultures from 1315463 patients, both Methicillin-resistant Staphylococcus aureus (MRSA) and Methicillin-sensitive Staphylococcus aureus (MSSA) were identified (Table 1). Methicillin resistance is independently associated with increased mortality and hospitalcharges among patients with S. aureus surgical site infections (SSI), therefore, we chose MRSA for in vitro studies [17]. Wires were twisted in a manner similar to that done during closing of sternotomy in the operating room and then incubated with MRSA PFGE strain type USA300 (source, Los Angeles correctional facility), for 24 h. Other wires from the same stock were used as un-inoculated controls. Examination of the wires under scanning electron microscope (SEM) showed attachment and accumulation of MRSA isolates on the wires within extracellular amorphous material forming three-dimensional structures (Fig. 1B). SEM imaging of the control wires showed no microorganisms attached to the metal surface (Fig. 1A). Biofilms associated with biomedical implant infections are known for their resistance to antibiotics [18]. To determine whether wire-associated bacteria show characteristics of classical biofilm bacteria described in the literature, the wires were inoculated with MRSA and challenged with tobramycin. The resistance to tobramycin was evaluated in wire-associated bacteriaSex M F F 18 CAD-HTN-HLD-PVD LVAD Vancomycin, Ciprofloxacin, Sulfamethoxazol, e-triethoprim, Linezoid Piperacillin-tazobactam, Vanomycin 12.1 weeks 40.9 CAD-HTN-HLD-RD-COPD Redo-MVR Ertapenem 2 weeks 34.7 CAD-DM-HTN-HLD-RF CABG Nafcillin, Daptomycin 5 weeks BMI Associated medical conditions Procedure Antimicrobial therapy Time interval between procedure and debridement Wound culture MSSA negative No growth Blood culture N N N Data shown in Figure # 3A, 4,6 6 7 M M M F F M 20.7 CGH-SVT AVR 50.2 HTN P-OSA-GERD-AKI LRB 41 HTN P HTN-RHD MVR Linezolid 23.7 END-SEP excision scar 9.2 weeks No growth MRSA 25.1 CAD- COPD-HLD-DM Fruquintinib chemical information PM-Repair of RV Piperacillin-tazobactam, Van.Teel wires used for sternotomy closure. (A) Left panel is a SEM at 60x magnification of an unused sterile stainless steel wire, twisted in a way similar to that after sternotomy closure. Scale bar = 1 mm. Right 1317923 panel is a higher magnification (10,000x) of the dashed box area in the left panel, showing the metal surface of the wire. Scale bar = 5 mm (B) Left panel is a SEM at 60x magnification of stainless steel wire after overnight incubation with MRSA strain USA300. Scale bar = 1 mm. Note the wire metal surface is coated by a film of material. Right panel is a higher magnification (10,000x) of the dashed box area in the left panel, showing clusters of cocci attached to the extracted wire and embedded within amorphous slime. Scale bar = 5 mm. doi:10.1371/journal.pone.0070360.gdebridement aimed at treating wound infection [14,15]. Given the poor prognosis of cardiac surgery wound infection complications, we sought to look for the presence of biofilm at the sternal wound site in patients undergoing cardiac surgery. This work provides the first direct evidence demonstrating presence of biofilm infection in sternal wound site cardiac surgery patients. The introduction of the concept of biofilm infection in deep SWI will help revisit wound management strategies.ResultsStainless steel wires used for approximation of the sternum after cardiac surgery were tested in vitro for bacterial adhesion, biofilm formation, and recalcitrance to antimicrobial tobramycin. In the SWI cultures from 1315463 patients, both Methicillin-resistant Staphylococcus aureus (MRSA) and Methicillin-sensitive Staphylococcus aureus (MSSA) were identified (Table 1). Methicillin resistance is independently associated with increased mortality and hospitalcharges among patients with S. aureus surgical site infections (SSI), therefore, we chose MRSA for in vitro studies [17]. Wires were twisted in a manner similar to that done during closing of sternotomy in the operating room and then incubated with MRSA PFGE strain type USA300 (source, Los Angeles correctional facility), for 24 h. Other wires from the same stock were used as un-inoculated controls. Examination of the wires under scanning electron microscope (SEM) showed attachment and accumulation of MRSA isolates on the wires within extracellular amorphous material forming three-dimensional structures (Fig. 1B). SEM imaging of the control wires showed no microorganisms attached to the metal surface (Fig. 1A). Biofilms associated with biomedical implant infections are known for their resistance to antibiotics [18]. To determine whether wire-associated bacteria show characteristics of classical biofilm bacteria described in the literature, the wires were inoculated with MRSA and challenged with tobramycin. The resistance to tobramycin was evaluated in wire-associated bacteriaSex M F F 18 CAD-HTN-HLD-PVD LVAD Vancomycin, Ciprofloxacin, Sulfamethoxazol, e-triethoprim, Linezoid Piperacillin-tazobactam, Vanomycin 12.1 weeks 40.9 CAD-HTN-HLD-RD-COPD Redo-MVR Ertapenem 2 weeks 34.7 CAD-DM-HTN-HLD-RF CABG Nafcillin, Daptomycin 5 weeks BMI Associated medical conditions Procedure Antimicrobial therapy Time interval between procedure and debridement Wound culture MSSA negative No growth Blood culture N N N Data shown in Figure # 3A, 4,6 6 7 M M M F F M 20.7 CGH-SVT AVR 50.2 HTN P-OSA-GERD-AKI LRB 41 HTN P HTN-RHD MVR Linezolid 23.7 END-SEP excision scar 9.2 weeks No growth MRSA 25.1 CAD- COPD-HLD-DM PM-Repair of RV Piperacillin-tazobactam, Van.